Made some good progress today. The engine is bolted in, the trans should be bolted in tomorrow.
Engine bolted in with the g54b mounts, the trans mount looks like it will be pretty simple. I flipped the crossmember off the lancer and used the stock starion mount. it seems to sit perfect, well other than I need to cut out about 2 1/2 inches out of the shifter area to get the trans up. I should be able to just make a small plate for the bottom of the slit and bolt it in I'm almost willing to bet they make a 5 speed mount for the lancer that would be a direct bolt on for the km132 starion trans, but eh, I'll do it this way for now.
The drive shaft should work once I go get a g63b mighty max slide yoke to swap onto the lancer driveshaft.
![Image](http://www.nwstarquest.com/coltlancer/coltlancer-g54b-01.jpg)
![Image](http://www.nwstarquest.com/coltlancer/coltlancer-g54b-02.jpg)