ITB selection? wanted to buy. Your thoughts!

[yno26galant]

Wanted to buy hyabusa itb or just wondering if anyones done this for the 2.6 astron. Or if somone has somthing similar that they want to sell ? Open to anything as the intake side of the are choking my 2.6 astron

[simon]

You could use ITBs of a Toyota 4age ( the silver top are 42mm and the black top are 45mm ).
I bought a set off a black top to put on a 4g67 ,but have not used them yet
Simon

[Mitsiman]

Twin DCOE weber manifold with EFI billet throttle bodies - or just go 45 DCOE webers will do everything the same as EFI on the vehicle without the extra expense of going EFI

[Rally_2.6LC]

I have quad carbies from a GSXR750 on a custom manifold made by Superscann811.
Work really well, easy to tune and balance.
Already the right spacing for a 4G32 also.
He has made a set off a GSXR1000 for his 2.6L which was in a Triton, went really well.
I'm pretty sure he has documented them on here also.


Cheers
Matt

[Taz]

Id say go for a twin Dellorto 40s or 45s but if the twin manifold is as hard to find as the 4g32 its not really feasable.
Dellorto > Weber all day every day though

[A112H]

i used two of the three throttle plates from a RB26DETT Skyline engine on a custom fabricated manifold.
I wanted something different and wanted to hide as much of the efi stuff underneath to keep a sort of carby look.
Most poeple think they are carbs until they look closer and start scratching their heads, lol
[/img]
[/img]
[/img]

[A112H]

Not been here for about a year and guess I did something wrong with the photo uploads, lol
Apparently there is no edit button anymore? Can someone fix the pics for me

[Old Colt]

I have done a Busa TB intake, These shots were quite early on.