My Sigma Drift Build
Posted: Tue Mar 22, 2011 2:43 pm
I decided to go away from the norm of having a Sigma burnout car and decided to try and turn one into a drift car. I have done enough skids in my time and decided now its time to start building a track car. So got this Sigma which has been in the family for the past 24 years.
Plans are to get it completely gutted and then get the entire body dead straight and rust free which is going to be a lot of fun around the windows due to the rust. Not 100% on what colour it will go yet but the entire outside and inside will be sprayed. Will be almost show quality when done rather than a cheap banger with mismatched panels and rust patches. And then I will smooth the engine bay and most likely SR20DET power it with a 5spd or a 6 spd depending on budget. The rear wheels will be getting kicked by shimmed LSD. Interior is going to be very basic. Just bare metal, a couple of race seats, few gauges, steering wheel cluster and maybe a couple of extra welded in brackets for strength. Mags will be whatever comes up at the time but would like some 16s or 17s. Suspension will be have to be made all in house with a coil over sleeve kit as no one seems to stock coil overs for a Sigma. Handbrake I am not sure on what direction I will go yet. But would like a hydraulic but will see. The entire fuel setup will be going into the boot. The tank will get the flick and I will get a fuel cell and a fuel pump or two.
I have only had it a few weeks. So far I have removed the entire interior and most of the engine accessories and head. All I need to do is get my hands on an engine crane so I can lift the block and gearbox out. Once that is done I will start the body work. Hopefully this weather decides to start getting better which probably wont happen due to winter so I may have to make a carport or cover to cover it up a bit.
Here are a few pics.
























Plans are to get it completely gutted and then get the entire body dead straight and rust free which is going to be a lot of fun around the windows due to the rust. Not 100% on what colour it will go yet but the entire outside and inside will be sprayed. Will be almost show quality when done rather than a cheap banger with mismatched panels and rust patches. And then I will smooth the engine bay and most likely SR20DET power it with a 5spd or a 6 spd depending on budget. The rear wheels will be getting kicked by shimmed LSD. Interior is going to be very basic. Just bare metal, a couple of race seats, few gauges, steering wheel cluster and maybe a couple of extra welded in brackets for strength. Mags will be whatever comes up at the time but would like some 16s or 17s. Suspension will be have to be made all in house with a coil over sleeve kit as no one seems to stock coil overs for a Sigma. Handbrake I am not sure on what direction I will go yet. But would like a hydraulic but will see. The entire fuel setup will be going into the boot. The tank will get the flick and I will get a fuel cell and a fuel pump or two.
I have only had it a few weeks. So far I have removed the entire interior and most of the engine accessories and head. All I need to do is get my hands on an engine crane so I can lift the block and gearbox out. Once that is done I will start the body work. Hopefully this weather decides to start getting better which probably wont happen due to winter so I may have to make a carport or cover to cover it up a bit.
Here are a few pics.























