Page 1 of 1
Rear swaybar
Posted: Fri Oct 26, 2012 7:37 pm
by webby
I know Scorpions didn't have one, or at least the three I have didn't.
Anyway, how would you go about mounting one? Stock Sigma swaybar, Sigma lower trailing arms, attach it to the diff/body somehow? Or am I completely off?
Re: Rear swaybar
Posted: Fri Oct 26, 2012 7:57 pm
by jvflash
You can buy them from the USA - Addco 349 Rear Anti Sway Bar Stabilizer Roll
eBay seller - neverenoughauto did carry them.
They sent me the install manual and the holes all line up with the Oz version.
Re: Rear swaybar
Posted: Sat Oct 27, 2012 7:24 am
by jvflash
Josh, PM sent to you.
Re: Rear swaybar
Posted: Tue Oct 30, 2012 6:09 pm
by Paddles
i use a selbys sway bar. they are great, they mount up with rubber bushes and 'U' brackets. only a couple hundred.
Re: Rear swaybar
Posted: Thu Nov 01, 2012 8:29 pm
by endlss
when the weather gets better i can take some fotos of the set up i have think its white line front and back , if it will help
i think i have a spare rear one in the shed
Re: Rear swaybar
Posted: Sun Nov 04, 2012 9:16 pm
by jvflash
They are back on eBay again about AU$155 when I looked
http://www.ebay.com.au/itm/Addco-302-Re ... 1c2947ad22
Re: Rear swaybar
Posted: Mon Nov 05, 2012 6:14 am
by webby
Cheers fellas.
Re: Rear swaybar
Posted: Fri Jun 21, 2013 5:26 pm
by BAD-SIG
I have a Whiteline PRM36 (could be BRM36 coz the sticker is slightly ripped) rear sway bar that I was told is from a GH Sigma that was used for circuit racing. I had a quick look under the rear of my GE Sigma and couldn't work out exactly how to mount the sway bar to the diff. Thanks for that diagram above, it has helped me a bit, but it would be great if someone with this bar fitted could post some photos of it, even if it's on a Scorpion. My GE Sigma has a banjo type diff which is basically a baby version of the Scorpion diff, so hopefully it all fits.