I want to swap over my speedo so that I have a working trip meter. The replacement speedo has a different coloured face plate . To replace the faceplate, first I have to remove the speedo needle.
Lots of different methods on youtube, but this one looks the easiest. Not sure if this is appropriate method for Sigma speedos though.
https://www.youtube.com/watch?v=avnTw3r1Bpk
Anyone had experience doing this.
Removing Speedo needle.
-
Sigmaproject
- Posts: 1143
- Joined: Sun Mar 22, 2009 7:11 am
- Location: Maitland NSW
Re: Removing Speedo needle.
I have just pulled them off in the past by grabbing the centre and pulling the needle off.
Putting them back on I put it about 10-20km mark, push on and then turn back to line up zero.
**note this is with GC/D Galant and GH Sigma gauges I have done...
Putting them back on I put it about 10-20km mark, push on and then turn back to line up zero.
**note this is with GC/D Galant and GH Sigma gauges I have done...
2* 73 A53 16L Dodge Colt (Plymouth Cricket), 2* 73 GB Galant Sedan's, 1* 74 GB Galant Sedan, 1* 76 VK Valiant Regal,
1* 79 GE SE Sigma Sedan, 1* 81 GH Sigma PWS, 1* 84 GK Sigma SE, 1* 85 GK Sigma GL - Replacing the 84 GK SE, 1* 91 GTO - FOR SALE
1* 79 GE SE Sigma Sedan, 1* 81 GH Sigma PWS, 1* 84 GK Sigma SE, 1* 85 GK Sigma GL - Replacing the 84 GK SE, 1* 91 GTO - FOR SALE
-
Sigmaproject
- Posts: 1143
- Joined: Sun Mar 22, 2009 7:11 am
- Location: Maitland NSW
Re: Removing Speedo needle.
Thanks for the reply. On one of the old forums there was a guy selling white faceplate kits for Scorpion instrument clusters and I thought that someone on this site may have been around back then and did the faceplate changover.
Only one way to find out
Only one way to find out