Just pull the old motor and sit the sigma one in the bay...might need modded/custom engine mounts and trans crossmember...i think ive seen 2.6's in corollas before
I need to replace the front seatbelts on a GK sigma for a rwc. Went to wreckers and found some good ones froma wagon, but turns out the bolt hole on the mount is in a slightly different spot. I would like to just buy new ones but they are $110 each! Can you get seatbelts re-coed, as in just put new ...
That is fricken psychotic. Heck they aren't even polished or anything. I'd say some people got a really good tax cheque and it'd most likely be from a couple of datsun guys desperate for em. They must have finally seen the light and avoided their trx 15 inch rims and decided the sigma ones are the ...
Can you just cut a hole in the firewall for the CAS an move the lot back to get the gearbox past the drag link?
Dont try to raise the engine/gearbox it will just mean your tailshaft is on a bad angle.
Yea there is one GC at centre road...hiding right at the back with the valiants and volvos! Ive been busy fixing a GK for RWC that I have not had time to do anything about my galant. Did grab a early scorp handbrake cable their today while getting some sigma bits for the gk, going to try to fit hand...
I called harveys and they aint got none.
Called centre road an they said they had them but didnt sound too convincing(their mostly pricks their).
Heading to centre road now.
Bleh, old Mistubishis are not worth alot of money. Infact you will find over the coming years prices will likely remain stable. New cars are cheaper and more available than ever before, less and less mechanics are capable of fixing old cars and as parts become harder to source less people will choos...
Just remove the air filter, then with one hand on the throttle just hold throttle open a little while slowlypouring water into the carb(make sure pour into the primay throat not secondary). Just blip the throttle as necessary to keep the motor from stalling. Ive done it many times on different cars/...
Hoonboy, I'l measure maybe on the weekend, car is not at my place currently been getting around on the R1 as the galant needs a few items attended to. B20 - You failed to answer my question, again. Before I had my struts shortened they would bottom out over big bump(and this was with 300lb springs!)...
http://www.sunrisejapanese.com/db/images/mitsubishi3.jpg 4g63 from fwd galant, sigma narrow 5 spd and scorp 3.3 diff.... Would be a bit more work than a 4g54/52.... Or just get a 4g54, rebuild the standard carb properly, use a 5spd and tallest diff you can find. Most sigmas are a bit crap of fuel b...
a stock manual 2.6 is a wide block, a stock auto 2.6 is narrow. all 2.0's are narrow.. all good? Yes and no.... GH's have a borg warner box and come in both Wide and narrow bolt patterns but thanks to the removable bellhousing you can use either wide or narrow with your box if you can find the matc...