front crossmember from vn dunnydore
front crossmember from vn dunnydore
Has anyone measured up a Commodore "K" frame? Would that graft into a Siggy? Would give you rack and pinion steer too.
'82 GJ GSR Silver (family heirloom):)
Re: front crossmember from vn dunnydore
dunno about a VN, but i ha look under my VX and the commo is Drastically wider than the siggy, so its highly unlikely its doable without MAJOR mods to either or both.
Insert witty one liner here -->
Re: front crossmember from vn dunnydore
If I remember right, the VT/VX is a fair bit wider than the VN-VS platform.
Had a look under my VC a while back and it looks closeish, and I know for a fact that a VN crossmember bolts into a VB-VL, so it might work. Dunno. Would probably need mods like Billsy said.
Had a look under my VC a while back and it looks closeish, and I know for a fact that a VN crossmember bolts into a VB-VL, so it might work. Dunno. Would probably need mods like Billsy said.
-Josh.
Daily: 7/96 EF Falcon, 4.0 SOHC, BTR95LE, 3.45:1 LSD/Lukey extractors, full 2.5” exhaust, EL intake, Tickford snorkel, 87DA cam, AU injectors, shiftkits.com.au single stage kit. PB 14.93@91mph.
Project: Red '81 Scorpion-http://www.sigma-galant.com/viewtopic.php?f=46&t=11889
Daily: 7/96 EF Falcon, 4.0 SOHC, BTR95LE, 3.45:1 LSD/Lukey extractors, full 2.5” exhaust, EL intake, Tickford snorkel, 87DA cam, AU injectors, shiftkits.com.au single stage kit. PB 14.93@91mph.
Project: Red '81 Scorpion-http://www.sigma-galant.com/viewtopic.php?f=46&t=11889
Re: front crossmember from vn dunnydore
Hmmm. Think I must investigate.
'82 GJ GSR Silver (family heirloom):)