Replacing Gauges on GD Coupe

[RaptorReed]

Been thinking about replacing the stock gauges on the '76 for some aftermarket ones such as these http://www.dakotadigital.com/index.cfm/ ... prd725.htm . A bit on the Expensive side, but it would replace some of the old wiring.

Board has been semi slow, so discuss!

[A112H]

I have been thinking about this myself, I believe 77galantv6 has fitted an aftermarket tacho into his factory dash and it looks good.
I like the look of these (in the old school white) but what to put in the 3rd hole in the dash?
http://www.dakotadigital.com/index.cfm/ ... prd726.htm

[RaptorReed]

Probably leave it blank, my car didn't come with a tacho as it is, or I've thought about the using three Autometer guages - Tacho, Speedo and a Quad Gauge.

Quad guage looks like this
http://autometer.com/cat_gaugedetail.as ... 594&sid=18

[GLANT]

they really are some pretty guages! top quality!

[colta51]

yea a set of them gauges (with that quad one) in a gc/gd dash woodnt look to out of place.. i dont think so anyway..?
anyone hav any piks of standed dash wiv after market gauges?

[77galantv6]

mine has autometer gauges - tacho and speedo,
will post up a pic if i can find the phone cable thingy

they fit exactly where the normal gauges go. from memory they are the 3 and 3/4 inch size

[77galantv6]

found some in a previous post of mine...

[astronturbo77]

in my lancer dash i have a autometer oil pressure gauge in the far right hole that used to be a air vent, and a boost gauge mounted behind the wheel on the steering coloum.

[RaptorReed]

Those Autometer ones do blend nicely as a good replacement, I think I may look into those instead.

[RaptorReed]

mine has autometer gauges - tacho and speedo,
will post up a pic if i can find the phone cable thingy
they fit exactly where the normal gauges go. from memory they are the 3 and 3/4 inch size

Did you mean 3 3/8 by chance, because I don't see a 3 3/4 size anywhere.