Dodge Colt stock am radio question

This section is for talk about anything to do with electrics, audio, lighting, etc.
Post Reply
Zsn0w
Posts: 1
Joined: Fri Jun 30, 2017 4:21 am

Dodge Colt stock am radio question

Post by Zsn0w »

I've got a 1974 dodge colt, equivalent to a GC Galant I believe, base coupe. It was a factory stereo delete car. I have combines the stereo from another gauge cluster and the tach from a third onto the original cluster, but I'm having problems with the wiring. There was a two prong plug on the gauge panel right near where the radio goes in that I assume plugs into the two prongs on the back of the AM radio. Is this correct? And if so, the three prongs left are for the speaker, then? I don't have a stock speaker to figure this out with unfortunately. If so, what's the third prong for? I'm going to need to find a different speaker to put in, so if anyone has the ohm rating of the all as well, that'd be helpful. If not, I'll just wire two 4 ohms on series to get 8 which should be safe. Thanks!
Post Reply