Head gasket wont fit overbored 4G52
Posted: Tue Oct 24, 2017 8:08 pm
Hey guys,
I've got a 4G52 which has been bored out to 90mm and the pistons sit 0.4mm proud of the block, built by previous owner and can't get in contact with them.
I cant use a standard head gasket and the 4G54 one is obviously too big in the piston bore at 92mm to use.
Has anyone bored an engine out this far or had custom head gaskets made?
Spoken to some people who say use a thin custom made copper head gasket.
I am wondering if anyone has used someone in Sydney and what the prices of copper gaskets was or know somewhere to get custom normal gaskets made.
Thanks
Matt
I've got a 4G52 which has been bored out to 90mm and the pistons sit 0.4mm proud of the block, built by previous owner and can't get in contact with them.
I cant use a standard head gasket and the 4G54 one is obviously too big in the piston bore at 92mm to use.
Has anyone bored an engine out this far or had custom head gaskets made?
Spoken to some people who say use a thin custom made copper head gasket.
I am wondering if anyone has used someone in Sydney and what the prices of copper gaskets was or know somewhere to get custom normal gaskets made.
Thanks
Matt