Looking for some jetting suggestions on twin 45s in a g54b
Posted: Thu Nov 17, 2016 8:02 am
I figure there may be a few more twin 45 builds down here that someone might be able to get me in the ballpark.
I'm using a late g54b flat toip with a small chamber head. Should be up around 11:1ish compression.
I will be getting a cam ground for it, but havent decided on a durration yet
Carburetors are dellorto dhla 45s on a short runner intake.
I'm going to opt for the biggest chokes I can, as I think the 45s might already be a bit small as I can only buy 40mm venturi/chole
I'd like to shoot for power up to about 7k rpm if possible, but thinking I may be under carbed
Anyhow, if anyone has some experience, and can get me in the general area, I would be much appreciated as i dont wanna go broke buying jetting
I'm using a late g54b flat toip with a small chamber head. Should be up around 11:1ish compression.
I will be getting a cam ground for it, but havent decided on a durration yet
Carburetors are dellorto dhla 45s on a short runner intake.
I'm going to opt for the biggest chokes I can, as I think the 45s might already be a bit small as I can only buy 40mm venturi/chole
I'd like to shoot for power up to about 7k rpm if possible, but thinking I may be under carbed
Anyhow, if anyone has some experience, and can get me in the general area, I would be much appreciated as i dont wanna go broke buying jetting