4g32 twin carb twin turbo
Posted: Fri May 15, 2015 6:57 pm
Hi guys.
Just picked up a set of twin dellorto's for my 4g32 (belt drive) and have been playing with the idea of putting a few small turbos for sh*ts n giggles.
My rather daft and long winded to answer question is this: what engine prep do i need to do to accomodate this? Not sure what lb id be running but itd be small, probably 10 or less. As far as i can tell/research there are no forged internals readily available for the 32 off the shelf unless if i have read right change it up to a 17-1800 odd cc and use pistons from another motor (cant remember which i vaguely remember reading this and cant find the page again). Anyone know what a forged 32 could handle - is 10-15lb well within its limits etc? I guess the next vague question is are there any "readily available" (and by that i mean i can pick up somewhere without searching for months on end etc) turbos that would be ideal for this application?
Cheers
Just picked up a set of twin dellorto's for my 4g32 (belt drive) and have been playing with the idea of putting a few small turbos for sh*ts n giggles.
My rather daft and long winded to answer question is this: what engine prep do i need to do to accomodate this? Not sure what lb id be running but itd be small, probably 10 or less. As far as i can tell/research there are no forged internals readily available for the 32 off the shelf unless if i have read right change it up to a 17-1800 odd cc and use pistons from another motor (cant remember which i vaguely remember reading this and cant find the page again). Anyone know what a forged 32 could handle - is 10-15lb well within its limits etc? I guess the next vague question is are there any "readily available" (and by that i mean i can pick up somewhere without searching for months on end etc) turbos that would be ideal for this application?
Cheers