Any tricks? It seems the whole chrome shaft and knob just keep spinning.
The previous owner of my GH fitted a manual drive train from a GE. I want to run the GH SE centre console. And need to get the knob off to go through the gearstick boot.
GE sigma gearknob removal
-
- Posts: 728
- Joined: Tue Mar 17, 2009 1:19 am
- Location: Central Coast
Re: GE sigma gearknob removal
If it's the factory knob then they just unscrew. They are a normal right hand thread, but there is usually a lock nut that is done up against the underside of the knob that needs to be loosened first.
Re: GE sigma gearknob removal
From memory I haven't seen one, but would expect one from previous cars. will have a look tomorrow
C_furnace is a name I remember from 10 years ago on the AUstarion forum when I had a Starion with the plates GADGET.
C_furnace is a name I remember from 10 years ago on the AUstarion forum when I had a Starion with the plates GADGET.
-
- Posts: 728
- Joined: Tue Mar 17, 2009 1:19 am
- Location: Central Coast
Re: GE sigma gearknob removal
Thats me. I haven't been on there in years though. I forgot my password and my email had changed and I've never gotten around to sorting it out.
Re: GE sigma gearknob removal
I found a circuit at the bottom of the chrome shaft that needs removal...i reckon once that's out something is gonna give.
Re: GE sigma gearknob removal
Circuit should have been circlip. All I had to do to get my knob off was Remove the circlip and pull my stick real hard and the knob and stick came off.