efi wiring question

[regor]

hey guys and gals. been a long time...wif wrok and junk

but i have finally have some free time to so some stuff wif 1 of my cars... :-)
my first car on my list is i have done teh efi setup on one of my sigma's...
now i wanna no if i can use the standard magna wiring and ecu to run it.. if so is there anything i need to do get it running or is it just wire in few wires for ignition and ect..i have a decent mount of wiring knowledge...and went aftermarket ecu wif my other 1 so i didnt need to worry bout it.. but this is going to be given to my dad.. and dont want to go over bored wif it...

so yeah can i use standart ecu and harnness out a magna...

cheers roger..
:-) :-)

[Cottees]

My EFI setup in my Sigma at the moment is a standard Magna setup. The only things that are different is no knock sensor or speedo sensor is connected, the loom was modified to fit into a RWD configuration and it is currently not running. If you look at my build, you can see what I have done. It has run before, I just have to get it to run properly.

viewtopic.php?f=48&t=1487

Here us the wiring diagram of how I attached the Sigma loom to the Magna loom.

[regor]

thanks heaps mate..
should be easy as now... :-)
cheers roger :-)