Sigma-galant.com

I want to swap over my speedo so that I have a working trip meter. The replacement speedo has a different coloured face plate . To replace the faceplate, first I have to remove the speedo needle.
Lots of different methods on youtube, but this one looks the easiest. Not sure if this is appropriate method for Sigma speedos though.
https://www.youtube.com/watch?v=avnTw3r1Bpk
Anyone had experience doing this.

I have just pulled them off in the past by grabbing the centre and pulling the needle off.
Putting them back on I put it about 10-20km mark, push on and then turn back to line up zero.

**note this is with GC/D Galant and GH Sigma gauges I have done...

Thanks for the reply. On one of the old forums there was a guy selling white faceplate kits for Scorpion instrument clusters and I thought that someone on this site may have been around back then and did the faceplate changover.
Only one way to find out