Sigma-galant.com

I think that would do it. The width I have is 18mm but height is 32mm, is the clip offset?

I think start with mould clips,

Looks close
Wouldn't mind some measurements!

Do these look familiar ? These are off the sill panel chrome strip. I'm yet to get some pics of the bonnet chrome strip clips

Thanks for that, rare spares have the belt mould clips, eBay nothing.

Does anyone have any leads to where I could purchase mould clips, for gh sigma?
Regards

Commodore runs the long shaft. I believe the ford has short input.
Located in Sydney.

I might sell it, unsure at the moment. I don't know if the EVO 1-3 bell housing pattern is the same as 4-9

Wide block/t56
EVO/t56
EVO/GM POWERGLIDE

It was quite easy. Bill Hincher makes a bell housing to suit.
I opted for the short shaft t56 magnum. With very very minimal auto tunnel mods, the box fits in easy.

Well, I think it's about time I shared some photos. Purchased this a few years ago. Mods are. Forged EVO ix mivec motor ported head kelford cams Motec m130 ecu drive by wire throttle Mark Williams 9 inch rear end, 40 spline axles aluminium bolt through centre. I initially had a T56 6 Spd manuel, cha...